MIMAKI JV5 Series User Manual

6-34
Setting the Display of Media Residual
Whether the screen displays the remaining amount of a medium is set.
1
Press the key in LOCAL to select the
printing mode.
2
Select [MEDIA RESIDUAL] of the maintenance menu.
(1) Press the key.
(2) Press to select [MAINTENANCE] and press the key.
(3) Press to select [MEDIA RESIDUAL].
3
Press the key.
4
Press to select ON/OFF.
5
Press the key.
6
Press the key several times to end the setting.
When "Remaining amount of a
medium to display" is set to ON,
the remaining amount of a medium is displayed in the remote mode.
(However, when a leaf medium is used, the length of the medium to be printed
is displayed.)
When "Remaining amount of a
medium to display" is set to OFF,
the remaining amount of a medium is not displayed in the remote mode.
• The amount of a medium that has been fed by the printing and jog keys is reflected in the remaining
amount of a medium.
• The length of a medium (initial value of the remaining amount) is entered when a roll medium is
detected. ( P.2-29)
• The setting configured here does not become effective unless media detection is performed after the
setting has been complete.
<LOCAL . 1> [ #01 ]
WIDTH:****mm
MED I A RES I DUA L
SETUP :
ON
MED I A RES I DUA L
SETUP :
OFF
MA I NT ENANCE
MED I A RES I DUA L < e n t >

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English