MIMAKI JV5 Series User Manual

7-7
7
Troubleshooting
Warning/Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take appropriate measures to remedy the displayed error.
Warning Messages
Message Cause Solution
Medium is not set. Set the medium.
The end of the life of the internal clock battery is
detected.
Contact our service office or the distributor in
your region.
Time to replace the wiper in the capping station
with a new one has come.
(The wiping count has reached the specified
value.)
Replace the wiper with a new one.
(P.6-8)
When the power supply has been kept turning
OFF for 72 hours or longer, sleep refresh or
cleaning was not performed.
Perform the test printing and check the nozzle
status.
If the power supply has been kept turning OFF
for a long time, the sleep operation must be
performed. ( P.6-23)
A heater is disconnected.
(This example shows that the preheater is
disconnected.)
Contact our service office or the distributor in
your region.
The thermistor of a heater is defective.
(This example shows that the thermistor of pre-
heater is defective.)
Ink for one supply path has been nearly used
up.
Replace the cartridge for the supply path
corresponding to the indicated color.
You can print without replacing the cartridge
(until "No ink" is displayed). However, the
machine returns to LOCAL each time when the
printing of one file is completed.
Ink for one supply path has been completely
used up.
Replace the cartridge for the supply path
corresponding to the indicated color.
Ink for one supply path is not set.
Or improper ink is set.
Replace or set the cartridge for the supply path
corresponding to the indicated color.
Refer to P. 7-5 "Ink Cartridge Warning Appears"
to check the details of the failure, and then fix the
problem following the applicable procedure.
Ink near end was detected right after the
cartridge with much remaining amount of ink
has been inserted.
Pull out the inserted cartridge and insert it again.
If the message will be displayed again, contact a
distributor in your district or our office to call for
service.
There is a problem with the installed ink
cartridges.
Check the warning details in the guidance
function. ( P.7-5)
** NO MEDIA **
! EXCHANGE BATTERY
<LOCAL . 1> [ #01 ]
Rep l a c e a WI PER<MNT>
<LOCAL . 1> [ #01 ]
!Do TEST PRINT
PRE PRT POST
BREAK * * ° C** ° C
PRE PRT POST
THERM * * ° C** ° C
<LOCAL . 1> [ #01 ]
NEAR END MMCC - - - -
*REMOTE. 1* [ #01 ]
NEAR END MMCC - - - -
<LOCAL . 1> [ #01 ]
INK END ----YYKK
*REMOTE. 1* [ #01 ]
INK END ----YYKK
<LOCAL . 1> [ #01 ]
!CARTRIDGE - - - -YYKK
*REMOTE. 1* [ #01 ]
!CARTRIDGE - - - -YYKK
<LOCAL . 1> [ #01 ]
RE I NSERT CARTR I DGE
<LOCAL . 1> !CAR [ #01 ]
*REMOTE. 1* !CAR [ #01 ]

MIMAKI JV5 Series Specifications

General

Brand	MIMAKI
Model	JV5 Series
Category	Printer
Language	English