2-46
Printing Data
Starting a Printing Operation
1
Set a medium. ( P.2-15)
2
Check the heater temperature.
• Check the CONSTANT lamp lights in [PRE], [PRINT], and
[POST] below the display.
3
Press the key in LOCAL.
• The screen changes to REMOTE, and data can be received from the
PC.
4
Transmit data to be printed from the PC.
• The pressure is switched automatically in concert with the pinch
roller pressure set in P. 3-6 "Setting for the Pinch Rollers".
• The ACTIVE lamp blinks and the printing conditions are displayed.
• For the method of data transmission, see the instruction manual for
the output software.
5
Start printing.
• The printing speed may change, depending on the width of the set
medium or the position of the print origin even when the same data
is printed. This is because of a difference in resolution.
• When using a roll medium, rewind the medium by hand before printing so that it is not loose. When the
roll medium has not been rewound tightly, it may cause the image quality to deteriorate.
• When switching the mode to the print mode after cutting data in the cut mode, “OFF” is displayed on
each heater temperature. Press the key twice, and then raise the heater temperature
up to the set temperature and perform printing.
To Next Page
Loading...
Need help?
General