Omron NX701-1 User Manual

Relevant Manuals
2
NJ/NX-series CPU Unit Motion Control User’s Manual (W507)
Relevant Manuals
The following provides the relevant manuals for the NJ/NX-series CPU Units.
Read all of the manuals that are relevant to your system configuration and application before you use
the NJ/NX-series CPU Unit.
Most operations are performed from the Sysmac Studio Automation Software. Refer to the Sysmac Stu-
dio Version 1 Operation Manual (Cat. No. W504) for information on the Sysmac Studio.
Purpose of use
Manual
Basic information
NX-series CPU Unit Hardware User’s Manual NX-series NX102 CPU Unit Hardware User’s Manual NX-series NX1P2 CPU Unit Hardware User's Manual NJ-series CPU Unit Hardware User’s Manual NJ/NX-series CPU Unit Software User’s Manual NX-series NX1P2 CPU Unit Built-in I/O and Option Board User's Manual NJ/NX-series Instructions Reference Manual NJ/NX-series CPU Unit Motion Control User’s Manual NJ/NX-series Motion Control Instructions Reference Manual NJ/NX-series CPU Unit Built-in EtherCAT Port User’s Manual NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual NJ/NX-series CPU Unit OPC UA User’s Manual NX-series CPU Unit FINS Function User’s Manual NJ/NX-series Database Connection CPU Units User’s Manual NJ-series SECS/GEM CPU Units User’s Manual NJ-series NJ Robotics CPU Unit User’s Manual NJ/NY-series NC Integrated Controller User’s Manual NJ/NX-series Troubleshooting Manual
Introduction to NX701 CPU Units 
Introduction to NX102 CPU Units 
Introduction to NX1P2 CPU Units 
Introduction to NJ-series Controllers 
Setting devices and hardware 
Using motion control 
Using EtherCAT 
Using EtherNet/IP 
Software settings 
Using motion control 
Using EtherCAT 
Using EtherNet/IP 
Using OPC UA

Using FINS

Using the database connection service 
Using the GEM Services 
Using robot control 
Using numerical control 
Using the NX1P2 CPU Unit functions 

Omron NX701-1 Specifications

General

Brand	Omron
Model	NX701-1
Category	Controller
Language	English