Omron NX701-1 User Manual

21
Versions
NJ/NX-series CPU Unit Motion Control User’s Manual (W507)
Versions
Hardware revisions and unit versions are used to manage the hardware and software in NJ/NX-series
Units and EtherCAT slaves. The hardware revision or unit version is updated each time there is a
change in hardware or software specifications. Even when two Units or EtherCAT slaves have the
same model number, they will have functional or performance differences if they have different hard-
ware revisions or unit versions.
You can check versions on the ID information indications or with the Sysmac Studio.
The unit version is given on the ID information indication on the side of the product.
The ID information on an NX-series NX701- CPU Unit is shown below.
Note The hardware revision is not displayed for the Unit that the hardware revision is in blank.
The ID information on an NX-series NX102- CPU Unit is shown below.
Note The hardware revision is not displayed for the Unit that the hardware revision is in blank.
Checking Versions
Checking Unit Versions on ID Information Indications
ID information indication
Lot number Serial number Unit version
MAC address Hardware revision
LOT No. DDMYY xxxx Ver.1.
PORT1 :  HW Rev. 
PORT2 : 
LOT No. DDMYY xxxx
PORT1

PORT2 
Ver.. HW Rev.
ID information indication
Lot number Serial numberUnit version
MAC address
Hardware revision

Omron NX701-1 Specifications

General

Brand	Omron
Model	NX701-1
Category	Controller
Language	English