102
Using the RD-700GX As a Master Keyboard
You can make changes in tones by adjusting the settings of the
following five elements.
ATK (Attack Time Offset):
The time it takes after the key is pressed for a sound to reach
full volume.
DCY (Decay Time Offset):
This is the time over which the volume decays after the attack
is finished.
REL (Release Time Offset):
The time it takes after the key is released for a sound to
become inaudible.
COF (Cutoff Offset):
Adjusts how much the filter is opened.
RES (Resonance Offset):
This boosts the portions in the region around the cutoff
frequency, lending a particular quality to the sound.
Excessively high settings can produce oscillation, causing the
sound to distort.
Portamento is a function that causes the pitch to change
smoothly from one note to the next note played.
The Portamento Time setting determines the time for the
change in pitch when the portamento effect is applied to the
sound. Higher settings will cause the pitch change to the next
note to take more time.
Set the change in volume that occurs in response to the force
used to play the keyboard (velocity) and the maximum value of
the change.
Changing Tone Elements
(ATK/DCY/REL/COF/RES)
Parameter
TX CC#
Value Description
ATK
CC73
- - - (OFF),
-64–+63
Higher values produce a
milder attack; lower
values produce a sharper
attack.
DCY
CC75
The time it takes for the
volume to fall increases as
the value is raised;
lowering the value
decreases the decay time.
REL
CC73
Higher values produce
longer decay; set lower
values for a clear-cut
sound.
COF
CC74
Higher values brighten the
sound; lower values make
the sound seem darker.
RES
CC71
Higher value makes the
special quality of the
sound stronger; lower
value reduce these
characteristics.
Smoothly Changing the Pitch
(Portamento)
Parameter
TX CC# Value
POR (Portamento Switch)
CC65
- - -, OFF, ON
P.T (Portamento Time)
CC5
- - -, 0–127
Setting the Change in Volume
According to the Force Used to Play the
Keyboard (Velocity Sensitivity/Max)
Parameter Value Description
Sns
(Velocity
Sensitivity)
-63–
+63
This setting determines how the
volume changes in response to
the velocity.
The volume is increased as the
keyboard is played with greater
force when a positive Value is
used; when a negative value is
selected, the volume decreases
as the keys are played with
greater force. If this is set to “0,”
the volume will not be affected
by the strength of your playing
on the keyboard.
MAX
(Velocity
Max)
1–127
This is the maximum velocity
value produced when you play
the keyboard.
Lowering this value will produce
softer notes even if you play the
keyboard strongly.
RD-700GX_e.book 102 ページ ２００８年２月１３日 水曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
