77
Making Detailed Settings for the ONE TOUCH Tones
You can make detailed settings to adjust the piano sound
that’s used when you press the ONE TOUCH [PIANO] button
(p. 35).
This function is called “Piano Designer.”
Furthermore, you can save up to three of the changed settings.
Piano Designer settings are stored in type A, B, or C of the
ONE TOUCH [PIANO] button.
When the ONE TOUCH [PIANO] button is
pressed, all settings other than the Piano Designer
settings are switched to their status at the time the
RD-700GX’s power was turned on.
Store any arrangements of settings that you want
to keep in Setup (p. 67).
1.
Press the [F1] button in the ONE TOUCH
PIANO screen to select the type you want to
set.
You can cycle through the types by pressing the [F1]
button.
2.
Press the [F2 (DESIGNER)] button.
A Piano Designer screen will appear.
fig.04-05-1g
3.
Press the Cursor [ ] [ ] buttons to switch
screens, and press the Cursor [ ] [ ]
buttons to move the cursor to the parameter to
be set.
Move the cursor to one of the following menus and press
the [ENTER] button, then select the parameter you want
to set in the screen that follows.
1. Key Touch Edit
2. Micro Tune Edit
3. Sym. Resonance
4. Equalizer
5. Tone Modify
6. Initialize
4.
Use the [DEC] [INC] buttons or the VALUE dial
to edit the value.
5.
If you want to save the setting, press the [F1
(WRITE)] button.
The confirmation message appears.
Press the [ENTER] button to save the settings. If you want
to cancel, press the [EXIT/SHIFT] button.
6.
When you finish making settings, press the
[EXIT/SHIFT] button.
You are returned to the ONE TOUCH PIANO screen.
Depending on the piano tone selected, this setting
may not be available.
This chooses the piano Tone to be selected when the ONE
TOUCH [PIANO] button is pressed.
There are 26 Tones to choose from.
Adjusts the spaciousness of the sound.
This changes the Tone’s subtle nuances by altering the phase
of the left and right sounds.
This effect is difficult to hear when headphones are
used.
Making Detailed Settings for the
Piano Tones (Piano Designer)
Making the Settings
NOTE
Selecting the Piano Sound
Changing the Width of the Sound
(Stereo Width)
Parameter
Value Description
Stereo Width
CENTER,
L01-01R–
L63-63R
The higher the value set, the
wider the sound is spread
out.
Changing the Sound’s Nuance
(Nuance)
Parameter
Value
Nuance
TYPE1, 2, 3
NOTE
NOTE
RD-700GX_e.book 77 ページ ２００８年２月１３日 水曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
