152
Error Messages/Other Messages
Error Messages
Indication:
Situation: Action:
Error 1
You can only read the music file.
You can only read the music file.
It can not be saved.
—
Error 2
An error occurred during writing.
An error occurred during writing.
The external media’s protect tab
may be in the “Protect” (writing
prohibited) position, or the external
media may not yet be initialized.
—
Error 10
No storage media is inserted.
No external media is inserted. Insert the external media and try again.
Error 11
Insufficient free memory at the save
destination.
There is not sufficient free memory
in the save destination.
Delete unneeded files (Songs or Setup files) you’ve saved in
internal memory and try again.
Error 14
An error occurred during reading
An error occurred during writing.
The external media may be
corrupted.
Insert other external media and try again. Alternatively, you
can initialize the external media.
Error 15
The data format is not compatible
with this instrument.
The file is unreadable. The data
format is not compatible with the
RD-700GX.
Only files in the following formats can be used.
• Setup files with an extension of “RDS”
• SMF music files with an extension of “MID”
• Audio files with an extension of “WAV,” “AIF,” or “MP3”
For details on audio file formats, refer to “Types of audio files
that the RD-700GX can play” (p. 153).
Error 16
Data could not be read fast enough
for playback of the song.
Data was not called up in time for
playback of the song.
You may be able to play the song after waiting a few
seconds.
Error 18
Supports 44.1kHz 16-bit linear
mono or stereo audio format and
MP3 format.
This audio format is not supported. Please use 44.1 kHz 16-bit linear WAV/AIFF format audio
files or MP3.
Error 30
Not enough storage space
available in the instrument.
The internal memory capacity of the
RD-700GX is full.
—
Error 40
The instrument can't deal with the
excessive MIDI data.
The RD-700GX cannot deal with the
excessive MIDI data sent from the
external MIDI device.
Reduce the amount of MIDI data sent to the RD-700GX.
Error 41
A MIDI cable has been
disconnected.
A MIDI cable has been
disconnected.
Connect it properly and securely.
Error 43
A MIDI transmission error has
occurred.
A MIDI transmission error has
occurred.
Check the MIDI cable and connected MIDI device.
Error 51
System error. Repeat procedure, or
cycle the power.
There may be a problem with the
system.
Repeat the procedure from the beginning. If it is not solved
after you have tried several times, contact the Roland service
center.
Error 65
The USB Memory port was
subjected to excessive current.
The USB MEMORY connector was
subjected to excessive current.
Make sure that there is no problem with the external media,
then turn the power off, then on again.
RD-700GX_e.book 152 ページ ２００８年２月１３日 水曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
