37
Performance
Tones selected with the [RHY/GM2] button are registered in the following order:
“Rhythm Sets,” “GM2 Rhythm Sets,” and “GM2 Tones.” Refer to the “Rhythm Set List”
(p. 192).
Each individual tone has a different tone number.
You can select tones with the TONE SELECT buttons by inputting numerals with these
buttons to specify tone numbers.
Turn the [NUM LOCK] button on when inputting numerals with the TONE SELECT buttons.
fig.Q1-07p
1.
Press the ONE TOUCH [PIANO] button or the ONE TOUCH [E. PIANO] button.
This selects a single tone to be played over the entire keyboard.
If multiple tones are playing, do not press the ONE TOUCH button, but instead select
the zone containing the tone to be changed using the Cursor buttons. Refer to
“Changing the Tone for a Zone” (p. 45).
2.
Press the [NUM LOCK] button to make the indicator light.
This enables input of numerals with the TONE SELECT buttons.
The numerical value that can be entered with each button is indicated beneath the buttons.
3.
Enter the tone number with the TONE SELECT buttons.
For example, to select tone number 125, you would press the TONE SELECT buttons in the order
of 1, 2, and 5.
4.
Press the [ENTER] button.
The tone is set.
Play the keyboard, and you will hear the selected tone.
The TONE SELECT buttons included in the selected Tone numbers lit.
Specifying the Tone Number to Select a Tone ([NUM LOCK] Button)
NOTE
RD-700GX_e.book 37 ページ ２００８年２月１３日 水曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
