84
Making Detailed Settings for the ONE TOUCH Tones
This adjusts the amount of hum and other noise that leaks into
the pickups.
Electric pianos were susceptible to various types of noise, and
this noise would sometimes be output along with the sounds of
the performance. Depending on the effect settings, such noises
can produce an authentic, lively atmosphere.
Depending on the selected Tone Type, this may
have no effect.
By changing the tuning type you can change the way in which
chords will resonate.
Depending on the selected Tone Type, this may
have no effect.
This adjusts the volume of the E. Piano tone.
You can apply effects that are tuned specifically for the E. piano.
The available parameters will depend on the effect you select.
THRU
No effect will be applied.
CHORUS
PHASER
FLANGER
Adjusting the Hum Noise (HUM Noise)
Parameter
Value Description
HUM Noise
-10–0–
+10
Adjusting this value from 0
toward the negative side will
produce a clearer sound,
while adjusting it toward the
positive side will produce a
dirty sound.
At a setting of -10 there will
be no hum at all.
Changing the Tuning Type
(Tuning Type)
Parameter
Value
Tuning Type
TYPE 1, TYPE 2
Adjusting the Volume (Level)
Parameter
Value
Level
0–127
NOTE
NOTE
Selecting an Effect (Effect Type)
Parameter
Value Description
Pre Delay
0.0–100.0 ms
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate Mode Hz, note
When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00 Hz Frequency of modulation (Hz)
Rate ( ) note (*1) Frequency of modulation (note)
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Balance
D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level
Parameter
Value Description
Rate Mode
Hz, note
When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00 Hz Frequency of modulation (Hz)
Rate ( ) note (*1) Frequency of modulation (note)
Depth 0–127 Depth of modulation
Resonance 0–127 Amount of feedback
Low Gain -15– +15 dB Boot or cut in the low end
High Gain -15– +15 dB Boot or cut in the high end
Level 0–127 Output Level
Parameter
Value Description
Pre Delay
0.0–100.0 ms
Adjusts the delay time from the direct
sound until the flanger sound is heard.
Rate Mode Hz, note
When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00 Hz Frequency of modulation (Hz)
Rate ( ) note (*1) Frequency of modulation (note)
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback -98– +98%
Adjusts the proportion of the flanger
sound that is fed back into the effect.
Negative (-) settings will invert the
phase.
RD-700GX_e.book 84 ページ ２００８年２月１３日 水曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
