87
Making Detailed Settings for the ONE TOUCH Tones
WURLY
This combines REED EP with a variation of it, reproducing a
typical E. piano sound of the '60s.
STAGE TWIN
This simulates playing through a guitar amp.
note
(*1)
:
fig.MFX-note2e
You can adjust the way in which the keyboard responds to
your playing touch.
→
“Changing the Key Touch (Key Touch)” (p. 79)
→
“Making Fine Adjustments to the Keyboard Touch (Key
Touch Offset)” (p. 79)
→
“Setting a Constant Volume Level in Response to the Playing
Force (Velocity)” (p. 80)
→
“Changing the Timing of Sounds in Response to the
Velocity (Velocity Delay Sensitivity)” (p. 80)
→
“Changing the Touch Sensitivity According to the Key
Range (Velocity Keyfollow Sensitivity)” (p. 80)
→
“Changing How Volume Responds to Your Dynamics (Key
Touch Mode)” (p. 80)
This restores the One Touch E. Piano settings to their initial
conditions.
1.
In Step 3 of the E. Piano Designer settings
instructions (p. 82), select “2. Initialize” and
press the [ENTER] button.
The Initialize Screen appears.
To cancel the Initialize, press the [EXIT/SHIFT] button.
2.
Press the [ENTER] button.
The confirmation message appears.
To cancel the procedure, press the [EXIT/SHIFT] button.
3.
Press the [ENTER] button once again.
The ONE TOUCH [E. PIANO] button’s tones are
initialized.
Parameter
Value Description
Treble
-50–+50
Amount of boost/cut for the high-
frequency range
Bass -50–+50
Amount of boost/cut for the low-
frequency range
Vibrato Sw OFF/ON Turns tremolo on/off.
Vibrato Rate
Mode
Hz/
When this is set to “note,” the effect is
synchronized with the tempo.
Vibrato Rate
(Hz)
0.05–10.00Hz Frequency of the tremolo (Hz)
Vibrato Rate
()
(*1) Frequency of the tremolo (note)
Vibrato Depth 0–127 Depth of the effect
Speaker Sim
LINE, OLD,
NEW, WURLY,
TWIN
Type of the speaker
* When “LINE” is selected, no
speaker used.
Level 0–127 Adjust the output level.
Parameter
Value Description
Treble
-50–+50
Amount of boost/cut for the high-
frequency range
Bass -50–+50
Amount of boost/cut for the low-
frequency range
Tremolo Sw OFF/ON Turns tremolo on/off.
Tremolo Rate
Mode
Hz/
When this is set to “note,” the effect is
synchronized with the tempo.
Tremolo Rate
(Hz)
0.05–10.00Hz Frequency of the tremolo (Hz)
Tremolo Rate
()
(*1) Frequency of the tremolo (note)
Tremolo Depth 0–127 Depth of the tremolo
Tremolo Duty -10–+10
Specifies the duty cycle of the LFO
waveform used to apply tremolo.
Increasing this value will increase the
duty cycle of the LFO waveform for the
L-channel; the duty cycle for the R-
channel will decrease.
Speaker Sim
LINE, OLD,
NEW, WURLY,
TWIN
Type of the speaker
* When “LINE” is selected, no
speaker used.
Level 0–127 Adjust the output level.
(Double note)(Dotted whole note),
(Dotted half note),
(Dotted thirty-second note),
(Whole note),
(Double-note triplet),
(Sixteenth-note triplet),
(Thirty-second note),
(Sixty-fourth-note triplet), (Sixty-fourth note), (Thirty-second-note triplet),
(Dotted eighth note),(Quarter-note triplet),(Eighth note),
(Half-note triplet),(Quarter note),
(Dotted quarter note),
(Whole-note triplet),
(Half note),
(Sixteenth note),
(Eighth-note triplet),
(Dotted sixteenth note),
Adjusting the Keyboard Touch
Response (Key Touch Edit)
Restore the settings to initial conditions
(Initialize)
RD-700GX_e.book 87 ページ 2008年2月13日 水曜日 午後5時49分