90
Making Detailed Settings for Tones
You can use the MULTI EFFECTS 1 [CONTROL] knob and
MULTI EFFECTS 2 [CONTROL] knob to control multi-effect
parameters in real time.
Here you can specify which parameters are to be controlled.
The parameters available for control differ depending on the
multi-effects assigned to MFX1 Type/MFX2 Type.
You can also make more detailed settings for the multi-effects.
When you select a multi-effect type, the individual parameters
for that type will be displayed.
For the values that can be edited, refer to “Effect/Parameter
List” (p. 154).
Depending on the multi-effect type, lowering the
volume of the part to which the multi-effect is
applied may change the character of the effect.
In this case, adjust the Level setting within the MFX
parameters.
Please be aware that if the Feedback parameter is
set to the minimum or maximum value, the sound
may continue indefinitely.
This sets the pitch of the tone.
1 cent = 1/100 semitone
With some Tones, there may be ranges in which
the pitch does not change as intended.
Portamento is a function that causes the pitch to change
smoothly from one note to the next note played.
With the Mono/Poly parameter set to MONO, portamento is
especially effective when simulating playing techniques such
as a violin glissandos.
The Portamento Time setting determines the time for the
change in pitch when the portamento effect is applied to the
sound. Higher settings will cause the pitch change to the next
note to take more time.
This sets the amount of pitch change that will occur when you
move the Pitch Bend lever (2 octaves).
Controlling the Multi-Effect Parameters
in Real Time (MFX 1/2 Control)
Parameter
Value
C1/2 (MFX 1/2
Control)
Refer to “Effect/Parameter List” (p.
154).
Other Multi-Effect Settings
Changing the Pitch
(Coarse Tune/Fine Tune)
Parameter
Value Description
Coarse Tune
-48–+48
(+/- 4 octaves)
Sets the sound’s pitch
in semitone units.
Fine Tune
-50–+50
(+/- 50 cents)
Sets the sound’s pitch
in units of one cent.
NOTE
NOTE
Creating Smooth Pitch Changes
(Portamento Switch/Portamento Time)
Parameter
Value
Portamento Sw
ON, OFF
Portamento Time
0–127
Changing the Bend Range
(Bend Range)
Parameter
Value
Bend Range
0–24 (semitone)
RD-700GX_e.book 90 ページ ２００８年２月１３日 水曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
