26
Getting Ready
1.
Before you switch on the power, turn the volume down all the way by moving the
VOLUME slider.
Also completely turn down the volume of any connected audio device and other equipment.
2.
Turn off the power to connected external devices.
3.
Press the lower portion of the [POWER ON] switch on the back of the RD-700GX.
The power is switched off.
If you need to turn off the power completely, first turn off the POWER ON switch, then unplug
the power cord from the power outlet. Refer to “Power Supply” (p. 7).
fig.00-11
1.
Adjust the volume using the VOLUME slider.
Move the slider up to increase the volume, or down to lower it.
Also adjust the volume of the connected device to an appropriate level.
The characters in the display may be difficult to view immediately after turning on the power or
after extended use; this may also be because of where and how the display is situated.
In such instances, adjust the display contrast by turning the [DISPLAY CONTRAST] knob on the
rear panel.
fig.00-17p
Turning Off the Power
Adjusting the Volume
Adjusting the Display Contrast ([DISPLAY CONTRAST] Knob)
NOTE
Rear Panel
RD-700GX_e.book 26 ページ ２００８年２月１３日 水曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
