1.2 Assembly overview - bonnet
1 - Bonnet
❑ Removing and installing
⇒ page 33
❑ Adjusting ⇒ page 51
2 - Adjustment buffer
3 - Seal in centre
❑ Left and right.
4 - Striker pin
❑ Removing and installing
⇒ page 46
❑ Adjusting ⇒ page 53
5 - Insulation
❑ Removing and installing
⇒ page 37
6 - Hinge
❑ Removing and installing
⇒ page 34
❑ Adjusting ⇒ page 51
7 - Support rod
❑ Removing and installing
⇒ page 40
8 - Lid lock
❑ Removing and installing
⇒ page 43
❑ Adjusting ⇒ page 52
9 - Bolt
❑ Qty. 2 on each side.
❑ Specified torque: 22 Nm
10 - Nut
❑ Qty. 2 on each side.
❑ Specified torque: 22 Nm
11 - Washer jets
❑ Removing and installing ⇒ Electrical system; Rep. gr. 92 ; Windscreen wiper system; Removing and
installing washer jets for windscreen wiper system .
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
General body repairs, exterior - Edition 08.2012
32 Rep. gr.55 - Bonnet, rear lid