YOKOGAWA GX20 User Manual

5-9
IM 04L51B01-01EN
Maintenance and Troubleshooting
1
2
3
4
5
App
Index
4-wireRTD/ResistanceType
Range CH1 CH2
20 ohm 0 Ω (short) 20Ω
Pt100-H 0 Ω (short) 160Ω
Pt100 0 Ω (short) 400Ω
2000 ohm 0 Ω (short) 2000Ω
Pt1000 0 Ω (short) 4000Ω
7 Tap Execute for the range you want to calibrate.
While calibration is in progress, a message indicating this appears. When the calibration is com-
plete, the message “Execution is complete” and the calibration value appear.
8 Repeat step 5 for every range.
9 When all the ranges have been calibrated, tap Write.
The calibration values will be saved.
To reset the A/D calibration values to their factory defaults, tap Reset.
You do not have to tap Write.
10 To calibrate a different module, wire the module to calibrate, tap Back, and perform
steps 4 to 7.
11 Tap Exit. A confirmation screen is displayed. Tap OK to exist calibration mode.
Operation complete
High-speed Universal Type
1 Tap the MENU key, Browse tab, Init/Calib, and menu A/D calibration.
The A/D calibration call-up screen appears.
2 Tap Execute.
A screen appears for you to conrm the switch to A/D calibration mode.
3 Tap OK.
The GX/GP restarts in A/D calibration mode.
4 Select the unit in which the module to calibrate is installed, and tap Next.
The module selection screen appears.
5 Select the module you want to calibrate, and tap Next.
The channel selection screen appears.
Go to calibration screen
Returns the calibration values to their factory defaults
Returns to the module selection screen
Exits from calibration mode
5.1 Maintenance

YOKOGAWA GX20 Specifications

General

Brand	YOKOGAWA
Model	GX20
Category	Recording Equipment
Language	English