<10. Other Functions>
10-18
IM 11M12G01-02EN 1sh Edition : Mar. 25, 2021-00
(1) “Converter menu” > “Maintenance” > “Communication settings.”
(2) Select “TCP settings” to setup.
Figure 10.24 TCP settings
Note
10.8 Save load
l Precautions When Using SD Card
• Be sure to format the SD card with SD Association software. If you use an SD card without
being formatted by the tool, operation is not guaranteed.
To download the formatter, select [Download] from the link below and proceed to SD
Memory Card Formatter.
https://www.sdcard.org
• Do not disconnect Power Supply or remove the SD card while accessing (reading/writing,
software updating) the SD card.
10.8.1 Log le output
• Maintenance report
Outputs the last three calibration and various set values.
• Measured value log
The following log data is output. Log cycle and measurement days can be selected from "1
second cycle × 8 days", "2 second cycle × 16 days", and "5 second cycle × 40 day
• Date and time
• Oxygen concentration
• Cell voltage
• CJ temperature
• Thermocouple temperature
• Simple cell resistance value
• NE107 Status
To Next Page
Loading...
Need help?
General
