5-58
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 5 Configuring Security Solutions
Configuring and Applying Access Control Lists
Note If you are planning to apply this ACL to the controller CPU, choose Any or Inbound
because a CPU ACL applies only to packets that are sent to the CPU, not packets from the
CPU.
h. From the Action drop-down box, choose Deny to cause this ACL to block packets or Permit to cause
this ACL to allow packets. The default value is Deny.
i. Click Apply to commit your changes. The Access Control Lists > Edit page reappears, showing the
rules for this ACL. See Figure 5-32.
Figure 5-32 Access Control Lists > Edit Page
The Deny Counters field shows the number of times that packets have matched the explicit deny
ACL rule. The Number of Hits field shows the number of times that packets have matched an ACL
rule. You must enable ACL counters on the Access Control Lists page to enable these fields.
Note If you want to edit a rule, click the sequence number of the desired rule to open the Access
Control Lists > Rules > Edit page. If you ever want to delete a rule, hover your cursor over
the blue drop-down arrow for the desired rule and choose Remove.
j. Repeat this procedure to add any additional rules for this ACL.
Step 8 Click Save Configuration to save your changes.
Step 9 Repeat this procedure to add any additional ACLs.
To Next Page
Loading...
Need help?
General
