Compaq LTE Elite User Manual

- Display cable
- Display latches
- Display clutches
- Display enclosure
4.10 Keyboard
4.11 Diskette drive and cable
4.12 Hard drive
- Hard drive security clips
4.13 Processor board
4.14 Power interface board (PIB)
4.15 PCMCIA ejector rails
4.16 Internal AC power supply
4.17 System board and I/O bracket
4.18 LED cable assembly
4.19 Computer base enclosure
4.20 PCMCIA compartment door
4.21 Battery pack/hard drive release latch assemblies
4.4 Preparation Procedures For Removal And Replacement
Before beginning removal and replacement procedures, complete the following
steps:
1. Read and observe the precautions in Section 4.1.
2. Turn off the computer.
3. Undock the computer if it is docked in an expansion base or a
convenience base (refer to Appendix D, "Docking and Undocking").
4. Disconnect the power cord.
5. Remove the battery pack (Section 4.5).
6. Remove any installed diskette.
7. Remove PCMCIA cards.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To prevent damage to the system unit or the peripheral devices, ensure that
the system unit power is off before connecting or disconnecting cables.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
8. Turn off all external devices, then disconnect them from the computer.
9. Close the display.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Electrostatic discharge (ESD) can damage electronic components. Be sure
that you are properly grounded before performing the following procedures.

Compaq LTE Elite Specifications

General

Brand	Compaq
Model	LTE Elite
Category	Laptop
Language	English