install optional devices, the computer may detect a configuration
change and prompt you to run Computer Setup. (Section 6.7).
o Verify that all required device drivers are installed.
o Verify that all required changes have been made to the CONFIG.SYS file.
o Verify that all required changes have been made to the AUTOEXEC.BAT file.
o Verify that printer drivers have been installed for each application.
o Determine whether an external device or its cable is responsible for the
problem by running POST with and without the external device connected.
NOTE: To deactivate most of the sensors for the purposes of troubleshooting
a problem, turn configuration switch number 6 off (Section C.2).
Turning switch number 6 off deactivates the keylock switch and all
sensors except for the motor position sensor and the computer-present
sensor.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Be sure to turn configuration switch number 6 back on when troubleshooting
is complete to avoid possible data loss or damage to the system that may
occur during docking or undocking.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
7.1 Troubleshooting Tables
This section contains troubleshooting information for diagnosing the
following problems with the SmartStation:
o Battery charging
o Docking/undocking
o Enclosure alignment
o Hardware installation
o LEDs
o Power
o SCSI
Table 7-1. Battery Charging Problems
===========================================================================
Problem Probable Cause Recommended Action(s)
===========================================================================
The battery charger Spare battery pack is No action is required.
LED on the expansion already fully charged. (Unless needed in the
base turns on briefly, computer, leave in the
then turns off. battery charging
compartment to maintain a
full charge.)
---------------------------------------------------------------------------
The battery charger The spare battery pack Remove the battery pack
LED on the expansion is not the correct and insert a Compaq LTE
base is flashing. battery pack for this Elite battery pack.
charger.
--------------------------------------------------
To Next Page
Loading...
Need help?
General