Screws
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Screws in the unit are not interchangeable. Damage may occur if you insert
an incorrect screw. As you remove screws, place them with the component you
removed to help avoid error.
To avoid stripping out plastic or metal parts, do not over tighten plastite
or taptite screws.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Plastics
Use care when handling the plastic case and battery charging compartment,
since they can be damaged from excessive force during removal and
replacement procedures.
Liners
The metal liners attached to the inside of the expansion enclosure are for
shielding purposes. Be careful not to damage the liners during removal and
replacement procedures. Be sure that the fingers of the liners make good
contact with the adjacent liners when replacing the bottom cover on the
unit.
Power Cord
The expansion base uses a three-prong grounded power cord that should be
connected to a grounded external outlet for safe operation.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The expansion base is designed for connection to a grounded (earthed)
electrical outlet. The grounding type plug is an important safety feature.
To avoid the risk of electric shock or damage to the equipment, do not
disable this feature.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
9.2 Tools Required
The following tools are required to service the expansion base:
o Flat-bladed screwdriver
o Torx T-8 screwdriver
o Torx T-10 screwdriver
o Torx T-15 screwdriver
o 3/16-inch nut driver (for screwlocks)
NOTE: Most of the screws in the expansion base are slotted Torx T-10 type,
which can be removed and replaced with a Torx T-10 or flat-bladed
screwdriver.
9.3 Removal And Re
lacement List
To Next Page
Loading...
Need help?
General