Compaq LTE Elite User Manual

is not attached or is contacts board is
damaged. attached properly to
the expansion base
system board.
2. Ensure that none of
the wires on the
battery contacts board
cable are damaged or
disconnected from the
rest of the cable. If
they are damaged or
disconnected, replace
the battery contacts
board. Route the cable
properly to ensure
that damage does not
reoccur (Section
9.14).
--------------------------------------------------
The battery contacts are 1. Ensure that all
damaged. battery contacts
are straight.
2. Replace the battery
contacts board and
route the wires
properly (Section
9.14).
--------------------------------------------------
The expansion base system Replace the expansion
board battery charging base system board.
circuitry is defective.
===========================================================================
Table 7-2a. Docking/Undocking Problems (Docking)
===========================================================================
Problem Probable Cause Recommended Action(s)
===========================================================================
The motor does not No power. 1. Ensure that the
engage and no beep is power cord is
emitted. properly connected
to the expansion
base.
2. Verify that the fan
is on and that the
VBatt1 and VBatt2
outputs from the
power supply are in
specification
(Section 10.2). If
the fan is not on
or the VBatt
outputs are out of
specification,
replace the power
supply.
3. Verify that the
power supply
connector has a
tight connection to
the vertical

Compaq LTE Elite Specifications

General

Brand	Compaq
Model	LTE Elite
Category	Laptop
Language	English