2478 - xx Advanced VGA BitBLT
test.
2480 - xx Advanced VGA Linedraw
test.
===========================================================================
Table 2-12. Audio Computer Checkup Error Codes
===========================================================================
Error Code Description Recommended Action
===========================================================================
3206 - xx Audio system internal Replace the system board.
error.
===========================================================================
Table 2-13. Network Controller Computer Checkup Error Codes
===========================================================================
Error Code Description Recommended Action
===========================================================================
6000 - xx Error occurred while 1. Run the ISA setup utility,
attempting to identify reconfigure the failing network
a particular network controller, and retest.
interface controller. 2. Ensure that the network
controller is seated properly,
if applicable.
3. Remove any cables attached to
the network controller(s) and
retest.
4. Ensure that any jumpers or DIP
switches on the controller
board are set to the correct
positions. (Refer to the
hardware documentation for more
information.)
5. If the network controller is a
stand-alone board, replace the
board.
6. If the network controller is
integrated into the expansion
base system board, replace the
expansion base system board.
7. If using multiple network
controller boards, attempt to
locate the defective board by
completing the following steps:
a. Remove all network
controller boards.
b. Install one network
controller board.
c. Retest with Computer
Checkup.
d. Keep adding the boards one
at a time and retesting
until the defective board is
located.
---------------------------------------------------------------------------
6001 - xx Network card setup The following steps apply to
failed. 6001 - xx and 6002 - xx error
codes:
To Next Page
Loading...
Need help?
General