----------------------------------------------
Defective system If the drive in the
board in expansion expansion base is
base. designated as secondary,
replace the system
board in the expansion
base.
----------------------------------------------
Defective system If the drive in the
board in computer. computer is designated
as secondary, replace
the system board in the
computer.
---------------------------------------------------------------------------
1793 - Secondary None Refer to probable Refer to recommended
Disk Controller causes for Error actions for Error Code
or Disk Failure Code 1792. 1792.
---------------------------------------------------------------------------
Audible 1 Short Power-on None.
successful.
---------------------------------------------------------------------------
Audible 2 Short Power-on None.
successful.
---------------------------------------------------------------------------
(RESUME = F1 None As indicated to Press the F1 key.
KEY) continue.
===========================================================================
2.3 Computer Checkup (Test)
After POST runs successfully, run the latest version of Computer Checkup
(TEST). Computer Checkup determines if the computer assemblies and options
are recognized by the system and functioning properly. Run Computer Checkup
after installing or connecting a new assembly or option.
Computer Checkup is installed on the hard drive. If the hard drive is not
functioning, you can run it from the Compaq Diagnostics diskette by
inserting the diskette in Drive A before turning on the computer.
NOTE: It is recommended that you make a diskette copy of Compaq Diagnostics
and keep it available for future need. If necessary, a copy can be
obtained from the Compaq Customer Support Center.
Running Computer Checkup
To run Computer Checkup from the hard drive, complete the following steps:
1. Turn off the computer.
2. Turn on the computer.
3. Press F10 immediately after the computer beeps and the cursor moves to
the upper-right corner of the screen.