Compaq LTE Elite User Manual

- The expansion base is locked with the key.
- The external options connector door is closed.
- A motor timeout occurs that is caused by physical interference
during docking, failure of the motor position sensor, etc.
===========================================================================
Docking the Compaq LTE Elite
To dock the Compaq LTE Elite in the Compaq SmartStation, complete the
following steps:
1. Connect the expansion base to an electrical outlet.
2. Turn off and disconnect any external devices that are connected to the
computer.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To avoid damage to the PCMCIA connector when docking and undocking, be sure
to remove any PCMCIA cards and cables that do not allow the PCMCIA
compartment door to fully close.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
3. Remove any cable or card that does not allow the PCMCIA compartment
door to fully close.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
An ISA expansion board with older technology could cause a conflict. To
prevent loss of data, save your files before docking with the computer on
or in Standby the first time you dock after an optional ISA expansion board
has been installed.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
4. If you are using a non-Windows environment or if you will need to use
optional devices that are connected to or installed in the expansion
base, turn off the computer. (Do not initiate Standby or Hibernation.)
5. If the monitor support cover is being used, close the computer display.
6. Slide open the external options door (Figure D-2).

Compaq LTE Elite Specifications

General

Brand	Compaq
Model	LTE Elite
Category	Laptop
Language	English