For example, with error code 6523-05, the first two-digit number of the
error code (65) indicates a disk problem (Table 2-14A). The second
two-digit number (23) indicates a random read (Table 2-14B). The last
two-digit number (05) indicates a seek failure (Table 2-14C). Thus, in this
example, the diagnostics program tested the random read functioning of the
hard drive and received a seek failure. The drive is faulty and must be
replaced.
NOTE: Refer to Chapter 7 for SCSI troubleshooting information.
Table 2-14A. SCSI Computer Checkup Error Codes - SCSI Device Names
===========================================================================
Error Code Description
===========================================================================
65xx - xx Disk
66xx - xx CD
67xx - xx Tape
===========================================================================
Table 2-14B. SCSI Computer Checkup Error Codes - SCSI Test Names
===========================================================================
Error Code Description
===========================================================================
xx00 - xx ID
xx05 - xx Read
xx06 - xx SA/Media
xx23 - xx Random Read
===========================================================================
Table 2-14C. SCSI Computer Checkup Error Codes - SCSI Test Error Codes
===========================================================================
Error Code Description Recommended Action
===========================================================================
xxxx - 02 Drive not installed. Check cable connections.
---------------------------------------------------------------------------
xxxx - 03 Media not in drive. Check for and install DATA CD
or write-enabled tape in drive.
---------------------------------------------------------------------------
xxxx - 05 Seek failure. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 06 Drive timed out. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 07 Drive busy. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 08 Drive already reserved. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 11 Media soft error. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 12 Drive not ready. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 13 Media error. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 14 Drive hardware error. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 15 Illegal drive command. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 16 Media was changed. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 17 Tape write protected. 1. Disable write protect on