Dell N3000 Series User Manual

Configuring OSPF and OSPFv3 1175
Configuring OSPFv3 Route Redistribution Settings
Beginning in Privileged EXEC mode, use the following commands to
configure OSPFv3 route redistribution settings.
Command Purpose
configure Enter global configuration mode.
ipv6 router ospf Enter OSPFv3 configuration mode.
redistribute {static |
connected} [metric
metric ] [metric-type {1 |
2}] [tag
tag ]
Configure OSPFv3 to allow redistribution of routes from
the specified source protocol/routers.
• static — Specifies that the source is a static route.
•
connected — Specifies that the source is a directly
connected route.
•
metric — Specifies the metric to use when
redistributing the route. (Range: 0–16777214)
• metric-type 1 — Type 1 external route.
•
metric-type 2 — Type 2 external route.
•
tag — Value attached to each external route, which
might be used to communicate information between
ASBRs. (Range: 0–4294967295)
exit Exit to Global Config mode.
exit Exit to Privileged EXEC mode.
show ipv6 ospf View OSPFv3 configuration and status information,
including information about redistributed routes.

Dell N3000 Series Specifications

General

Managed	Yes
Stacking Ports	2 x 10GbE SFP+
Weight	12.3 lbs (5.6 kg)
Operating Temperature	32° to 113°F (0° to 45°C)
Ports	24 or 48 10/100/1000 ports