Dell N3000 Series User Manual

Setting Basic Network Information 161
Configuring Basic Network Information (CLI)
This section provides information about the commands you use to configure
basic network information on the Dell Networking N2000, N3000, and N4000
series switches. For more information about these commands, see the
Dell
Networking N2000, N3000, and N4000 Series Switches CLI Reference Guide
at support.dell.com/manuals.
Enabling the DHCP Client on the OOB Port
NOTE: N2000 switches do not have an out-of-band interface.
Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the OOB port.
Enabling the DHCP Client on the Default VLAN
Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the default VLAN, which is VLAN 1. As a best practice,
it is recommended that a separate VLAN other than one used for client traffic
be used for in-band management of the switch. In general, using VLAN 1, or
any other VLAN carrying client traffic, for in-band management introduces a
security vulnerability.
Command Purpose
configure Enter Global Configuration mode.
interface out-of-band Enter Interface Configuration mode for the OOB port.
ip address dhcp Enable the DHCP client.
CTRL + Z Exit to Privileged EXEC mode.
show ip interface out-of-
band
Display network information for the OOB port.
Command Purpose
configure Enter Global Configuration mode.
interface vlan 1 Enter Interface Configuration mode for VLAN 1.
ip address dhcp Enable the DHCP client.
ipv6 address dhcp Enable the DHCPv6 client.

Dell N3000 Series Specifications

General

Managed	Yes
Stacking Ports	2 x 10GbE SFP+
Weight	12.3 lbs (5.6 kg)
Operating Temperature	32° to 113°F (0° to 45°C)
Ports	24 or 48 10/100/1000 ports