Digi Connect IT 4 User Manual

Routing IP routing
Digi Connect IT® 4 User Guide
258
Configure a static route
A static route is a manually configured routing entry. Information about the route is manually entered
rather than obtained from dynamic routing traffic.
Required configuration items
n The destination address or network.
n The interface to use to reach the destination.
Additional configuration items
n A label used to identify this route.
n The IPv4 address of the gateway used to reach the destination.
n The metric for the route. When multiple routes are available to reach the same destination, the
route with the lowest metric is used.
n The Maximum Transmission Units (MTU) of network packets using this route.
To configure a static route:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Routes > Static routes.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English