Digi Connect IT 4 User Manual

Firmware configuration Review Connect IT 4 default settings
Digi Connect IT® 4 User Guide
27
Review Connect IT 4 default settings
You can review the default settings for your Connect IT 4 device by using the local WebUI or Digi
Remote Manager:
Local WebUI
1. Log into the Connect IT 4 WebUI as a user with Admin access. See Using the local web interface
for details.
2. On the menu, click System > Device Configuration.
Digi Remote Manager
1. If you have not already done so, connect to your Digi Remote Manager account.
2. From the menu, click Devices to display a list of your devices.
3. Locate your device as described in Use Digi Remote Manager to view and manage your device.
4. Click the Device ID.
5. Click Settings.
6. Click to expand Config.
The following tables list important factory default settings for the Connect IT 4.
Default interface configuration
Interface type
Preconfigured
interfaces Devices Default configuration
Wide Area Networks (WAN)
n WAN n Ethernet:
WAN
n Firewall zone: External
n WAN priority: Metric=1
n IP Address: DHCP
client
n Digi SureLink
TM
enabled for IPv4
Wireless Wide Area
Networks (WWAN)
n Modem n Modem n Firewall zone: External
n WAN priority: Metric=3
n SIM failover after 5
attempts
Local Area Networks (LANs)
n LAN n Ethernet: LAN n Firewall zone: Internal
n IP address:
192.168.2.1/24
n DHCP server enabled
n LAN priority: Metric=5
n Loopback n Ethernet:
Loopback
n Firewall zone:
Loopback
n IP address: 127.0.0.1/8

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English