Digi Connect IT 4 User Manual

Services Configure DNS
Digi Connect IT® 4 User Guide
502
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show DNS server
You can display status for DNS servers. This command is available only at the Admin CLI.
Command line
Show DNS information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show dns command at the system prompt:
> show dns
Interface Label Server Domain
--------- ----- ------------------------ ------
wan 192.168.3.1
wan fd00:2704::1
wan fe80::227:4ff:fe2b:ae12
wan fe80::227:4ff:fe44:105b
wan fe80::240:ffff:fe80:23b0
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English