Digi Connect IT 4 User Manual

Firmware configuration Change the default password for the admin user
Digi Connect IT® 4 User Guide
28
Interface type
Preconfigured
interfaces Devices Default configuration
n Default IP n Ethernet: LAN n Firewall zone: Setup
n IP address
192.168.210.1/24
n Default Link-
local IP
n Ethernet: LAN n Firewall zone: Setup
n IP address
169.254.100.100/16
Other default configuration settings
Feature Configuration
Central
management
n Digi Remote Manager enabled as the central management service.
Security policies
n Packet filtering allows all outbound traffic.
n SSH and web administration:
l Enabled for local administration
l Firewall zone: Internal
Monitoring
n Device heath metrics uploaded to Digi Remote Manager at 60 minute
interval.
n SNMP: Disabled
Serial port
n Enabled
n Serial mode: Login
n Label: None
n Baud rate: 9600
n Data bits: 8
n Parity: None
n Stop bits: 1
n Flow control: None
Change the default password for the admin user
The unique, factory-assigned password for the default admin user account is printed on the bottom
label of the device and on the loose label included in the package.
If you erase the device configuration or reset the device to factory defaults, the password for the
admin user will revert to the original, factory-assigned default password.
Note If your device was manufactured prior to the release of firmware version 19.11.x, the default
user name may be root.
To change the default password for the admin user:
Web

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English