Digi Connect IT 4 User Manual

Interfaces Local Area Networks (LANs)
Digi Connect IT® 4 User Guide
155
a. Add a MACaddress to the denylist:
(config network interface my_lan)> add mac_denylist end mac_address
(config network interface my_lan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MACaddress.
10. (Optional) Configure the MAC address allowlist.
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
a. Add a MACaddress to the allowlist:
(config network interface my_lan)> add mac_allowlist end mac_address
(config network interface my_lan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MACaddress.
11. Save the configuration and apply the change:
(config network interface my_lan)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the WAN port as a LAN or in a bridge
By default, the WAN Ethernet port on your Connect IT 4 is configured to function as a WAN port, which
means that it:
n Uses the External firewall zone.
n Receives its IPv4 address from an upstream DHCP server.
n Has SureLink enabled to test the quality of its internet connection.
Alternatively, you can configure the WAN port to function as a LAN port, or you can include the WAN
port in the default LAN1 bridge or create a bridge that includes the WAN port with and ETH2 ports.
This section contains the following topics:

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English