Digi Connect IT 4 User Manual

Services Configure SSHaccess
Digi Connect IT® 4 User Guide
481
Configure SSHaccess
The Connect IT 4's default configuration has SSHaccess enabled, and allows SSHaccess to the device
from authorized users within the Internal firewall zone. If this configuration is sufficient for your
needs, no further configuration is required. See Allow remote access for web administration and SSH
for information about configuring the SSHservice to allow access from remote devices.
Required configuration items
n Enable SSHaccess.
n Configure access control for the SSHservice.
Additional configuration items
n Port to use for communications with the SSHservice.
n Multicast DNS (mDNS) support.
n A private key to use for communications with the SSHservice.
n Create custom SSHconfiguration settings.
See Set the idle timeout for Connect IT 4 users for information about setting the inactivity timeout for
the SSH service.
Enable or disable the SSHservice
The SSH service is enabled by default. To disable the service, or enable it if it has been disabled:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English