EasyManuals Logo
Home>Digi>Network Router>Connect IT 4

Digi Connect IT 4 User Manual

Digi Connect IT 4
964 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #470 background imageLoading...
Page #470 background image
Services Configure the web administration service
Digi Connect IT® 4 User Guide
470
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add the External zone to the SSH service:
(config)> add service ssh acl zone end external
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the web administration service
The web administration service allows you to monitor and configure the Connect IT 4 device by using
the WebUI, a browser-based interface.
By default, the web administration service is enabled and uses the standard HTTPS port, 443. The
default access control for the service uses the Internal firewall zone, which means that only devices
connected to the Connect IT 4's LANcan access the WebUI. If this configuration is sufficient for your
needs, no further configuration is required. See Allow remote access for web administration and SSH
for information about configuring the web administration service to allow access from remote
devices.
Required configuration items
n The web administration service is enabled by default.
n Configure access control for the service.
Additional configuration items
n Port to use for web administration service communication.
n Multicast DNS (mDNS) support.
n An SSL certificate to use for communications with the service.
n Support for legacy encryption protocols.
See Set the idle timeout for Connect IT 4 users for information about setting the inactivity timeout for
the web administration services.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi Connect IT 4 and is the answer not in the manual?

Digi Connect IT 4 Specifications

General IconGeneral
BrandDigi
ModelConnect IT 4
CategoryNetwork Router
LanguageEnglish

Related product manuals