Digi Connect IT 4 User Manual

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 4 User Guide
55
Wide Area Networks (WANs)
The Connect IT 4 device is preconfigured with one Wide Area Network (WAN), named WAN, and one
Wireless Wide Area Network (WWAN), named Modem.
You can modify configuration settings for the existing WAN and WWANs, and you can create new WANs
and WWANs.
This section contains the following topics:
Wide Area Networks (WANs) and Wireless Wide Area Networks (WWANs) 56
Configure WAN/WWAN priority and default route metrics 56
WAN/WWAN failover 59
Configure SureLink active recovery to detect WAN/WWAN failures 60
Configure the device to reboot when a failure is detected 77
Disable SureLink 90
Example: Use a ping test for WAN failover from Ethernet to cellular 99
Using Ethernet devices in a WAN 101
Using cellular modems in a Wireless WAN (WWAN) 102
Configure a Wide Area Network (WAN) 125
Configure a Wireless Wide Area Network (WWAN) 133
Show WAN and WWAN status and statistics 143
Delete a WAN or WWAN 145
Default outbound WAN/WWAN ports 146

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English