Digi Connect IT 4 User Manual

Services Modbus gateway
Digi Connect IT® 4 User Guide
538
Velocity : 0 meters per second
Direction : None
Quality : Standard GNSS (2D/3D)
UTC Date and Time : Wed, May 3, 2023 21:24:00 03
No. of Satellites : 7
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show geofence information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
Connect IT 4 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show location geofence command at the system prompt:
> show location geofence
Geofence Status State Transitions Last Transition
------------- ------ ------ ----------- ---------------
test_geofence Up Inside 0
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Modbus gateway
The Connect IT 4 supports the ability to function as a Modbus gateway, to provide serial-to-Ethernet
connectivity to Programmable Logic Controllers (PLCs), Remote Terminal Units (RTUs), and other
industrial devices. MODBUS provides client/server communication between devices connected on
different types of buses and networks, and the Modbus gateway allows for communication between
buses and networks that use the Modbus protocol.
This section contains the following topics:
Configure the Modbus gateway 539
Show Modbus gateway status and statistics 552

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English