Digi Connect IT 4 User Manual

Firewall Configure custom firewall rules
Digi Connect IT® 4 User Guide
739
dst_zone any
enable true
ip_version any
label Allow all outgoing traffic
protocol any
src_zone internal
1
action drop
dst_zone internal
enable true
ip_version any
label My packet filter
protocol any
src_zone external
(config)>
4. To delete the rule, use the index number with the del command. For example:
(config)> del firewall filter 1
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure custom firewall rules
Custom firewall rules consist of a script of shell commands that can be used to install firewall rules,
ipsets, and other system configuration. These commands are run whenever system configuration
changes occur that might cause changes to the firewall.
To configure custom firewall rules:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English