Digi Connect IT 4 User Manual

Virtual Private Networks (VPN) NEMO
Digi Connect IT® 4 User Guide
458
>
3. To display details about a specific tunnel:
> show l2tpeth name /vpn/l2tpeth/test/session/test
test/session/test Tunnel Session Status
---------------------------------------
Enabled : true
Status : up
Local IP : 4.3.2.1
Remote IP : 10.10.10.1
Tunnel ID : modem
Peer Tunnel ID : 10.10.10.1 === 4.3.2.1
Session ID : 255
Peer Session ID : 1476
Lifetime (Actual) : 600
Device : le_test_test
RX Packets : 2,102
RX Bytes : 462
TX Packets : 2,787
TX Byptes : 3,120
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
NEMO
Network Mobility (NEMO) is a mobile networking technology that provides access to one or more
Local Area Networks (LANs) on your device. NEMO creates a tunnel between the home agent on the
mobile private network and the Connect IT 4 device, isolating the connection from internet traffic and
advertising the IP subnets of the LANs for remote access and device management.
Dynamic Mobile Network Routing (DMNR) is the implementation of NEMO for Verizon Wireless Private
Networks. DMNR support requires the use of Verizon SIM cards that have DMNR enabled.
Configure a NEMO tunnel
Configuring an NEMO tunnel with a remote device involves configuring the following items:
Required configuration items
n Enable the NEMO tunnel.
The NEMO tunnel is enabled by default.
n The IP address of the NEMO virtual network interface.

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English