Digi Connect IT 4 User Manual

Firewall Configure Quality of Service options
Digi Connect IT® 4 User Guide
750
viii. Set the source address type:
(config network qos 2 policy 0 rule 0)> src type value
(config network qos 2 policy 0 rule 0)>
where value is one of:
n any: Source traffic from any address will be matched.
See Firewall configuration for more information about firewall zones.
n interface: Only traffic from the selected interface will be matched. Set the
interface:
i. Use the ? to determine available interfaces:
(config network qos 2 policy 0 rule 0)> src interface ?
Interface: Match the IP address with the specified
interface's network address.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network qos 2 policy 0 rule 0)> src interface
ii. Set the interface. For example:
(config network qos 2 policy 0 rule 0)> src interface
/network/interface/wan
(config network qos 2 policy 0 rule 0)>
n address: Only traffic from the IP address typed in IPv4address will be
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
n address6: Only traffic from the IP address typed in IPv6address will be
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
n mac: Only traffic from the MACaddress typed in MACaddress will be matched.
Set the MAC address to be matched:

Digi Connect IT 4 Specifications

General

Brand	Digi
Model	Connect IT 4
Category	Network Router
Language	English