Eaton easyE4 User Manual

4. Operation
4.5 Your first EDP program
4.5.4 Delete Program
The DELETE PROGRAM function not only deletes the circuit diagram but all elements
of a program. These are as follows:
l
Circuit Diagram
l
Function block list
l
Function block diagram
l
Screens
The system settings and operating parameters are reset to the default settings and
also a possible NET parameterization.
Proceed as follows to delete the program in the easyE4 device:
easyE4 must be in STOP mode in order to extend, delete or modify the circuit dia-
gram.
Switch the easyE4 device to STOP mode.
From the main menu, go to the SYSTEM OPTIONS menu.
 Opens additional menus
STOP ✓ RUN
PARAMETERS
SET CLOCK
CARD
INFORMATION
SYSTEM OPTIONS
PROGRAM
Tab. 64: Main menu
SECURITY
SYSTEM
MENU LANGUAGE
DELETE PROGR.
NET
ETHERNET
UPDATE
Tab. 65: System options
DELETE PROGRAM?
YES
NO
Tab. 66: System option-
s\Delete progr.
Select DELETE PROGRAM.
The easyE4 device will show a confirmation prompt.
Select YES.
Press the OK button to delete the program
or
Press the ESC button to cancel
Pressing the ESC button once more returns you to the previous menu level.
easyE402/24 MN050009ENEaton.com
179

Eaton easyE4 Specifications

General

Brand	Eaton
Model	easyE4
Category	Relays
Language	English