4. Operation
4.6 Transfer program to the easyE4 device
4.6 Transfer program to the easyE4 device
There are two options for directly transferring a finished .e80 program to an easyE4
device.
l
With a microSD memory card
l
With a direct Ethernet connection between the PC and easyE4
4.6.1 Transfer with a microSD memory card
Prerequisites
l
You will temporarily need a suitable microSD memory card with a maximum stor-
age capacity of 32 GB.
l
A PC with easySoft 8 programming software installed on it, → Section "Install-
ation instructions", page 98
Insert the microSD memory card into a drive on your PC (with a suitable adapter
if necessary).
Open the easySoft 8 programming software on your PC.
Create an application program and save it.
Use the help in the menu by accessing the help topics with the
F1 key or open the easyE4 manual.
or
Open a sample program.→ Section "Sample projects", page 839
Make sure to stay in the Project view, as the Project menu will only be
available there.
Application examples
Support has provided a number of applications that are available for download as ZIP
files from the Software Download Center.
Download Center - Software
Eaton.com/software/Anwendungsbeispiele/easy/Deutsch
Eaton.com/software/Application Samples/easy/English
These examples come with a task description, the circuit diagram, and the
easySoft project (in the EDP and LD programming languages as of this writing).
180
easyE402/24 MN050009ENEaton.com
To Next Page
Loading...
Need help?
General