5. Programming on the device
5.1 Program
5. Programming on the device
This chapter describes how to wire easyE4 contacts and coils with the display and
keypad on an
EASY-E4-...-12...C1(P).
5.1 Program
An easyE4 program consists of the required system settings for the easyE4 device,
NET, password, and operating parameters,
as well as the following:
l
Circuit diagram (program on the easyE4)
l
Function block list
l
Function block diagram
Programs have file extension .e80. However, please note that this file
extension will not be shown on the display.
The programs themselves can be created very easily with easySoft 8
and then transferred to the easyE4 device.
easySoft V8 provides corresponding support.
5.2 Circuit diagram display
The circuit diagram, i.e., the program with which the EASY-E4-...-12...C1(P) works,
can be displayed in the main menu under Program.
Programs/Circuit Diagram
Fig. 95: Circuit diagram display
In the easyE4 circuit diagram, contacts and coils of relays are connected up from left
to right - from the contact to the coil.
The circuit diagram is created on a hidden wiring grid containing contact fields, coil
fields and rungs. It is then wired up with connections.
l
Insert contacts in the four contact fields. The first contact field on the left is auto-
matically connected to the voltage.
l
The coil field can be used to enter the relay coil being driven together with the
corresponding coil identifier and coil function. The coil identifier consists of a coil
easyE402/24 MN050009ENEaton.com
187
To Next Page
Loading...
Need help?
General