3. Configure the Camera No., Registration Mode (IP address/domain name), IP address/ Domain name, Port,
User Name, Password, Channel No. and Factory (protocol type) to add the IP camera.
4. Click OK to save the settings.
5. On the Channel List interface, click Apply to finish the adding of the IP camera.
Editing Status of Analog Camera:
For Hybrid DVR, you can view the status of the connected analog camera, as well as increase the number of IP
camera to add by changing the disabling the analog camera (s).
1. Click the Analog List tag to enter the analog camera management interface. You can the information of the
connected analog camera.
2. Click Status to enter the Analog Camera Status interface.
Figure 4. 24 Editing Status of Analog Camera
3. You can de-select the camera (s) to disable the analog camera(s) connected.
Note: Please refer to the User Manual of DS-9000 or DS-7600 for detailed instructions.
4.1.4 Alarm Settings
Click Alarm on the remote settings interface to enter the Alarm Settings interface where you can configure the
alarm input, alarm output and manual alarm.
Figure 4. 25 Alarm Settings
1. Configuring Alarm Input
(1) Click Set beside Alarm Input to enter the Alarm Input Settings interface.
(2) Select the alarm input for configuration.
(3) Edit the Alarm Name.
(4) Select the Alarm Type to Normally Open or Normally Close.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
