OPERATOR'S STATION
1-97
Wiper/Washer Switch
The wiper and the window washer are operated using the
wiper/washer switch.
Wiper
Turn the wiper/washer switch to the specified position to
operate the wiper.
OFF The wiper stops and is retracted.
INT Position The wiper operates intermittently at the
interval selected by the switch position
as described below. INT mode has three
positions of operating speed as shown
below.
INT (Slow): The wiper operates at 8-second interval.
INT (Mid): The wiper operates at 6-second interval.
INT (Fast): The wiper operates at 3-second interval.
ON The wiper operates continuously.
f
NOTE: When the front window (upper) is opened, the wiper
and washer will not operate. If the front window is opened
while operating the wiper, the wiper stops.
Washer
Push and hold the wiper/washer switch to squirt washer
fluid onto the front window. When the wiper/washer switch
is pressed for more than 2 seconds, the wiper operates until
the switch is released. When the wiper/washer switch is
released, the wiper automatically retracts.
When operating the wiper in INT mode, while push
and hold the wiper/washer switch, the wiper operates
continuously.
f
NOTE: The wiper motor protection control stops wiper
operation, to prevent it from becoming stuck when operated
for long period of time under high load. When the wiper stops,
do not change the arm position and wait several minutes
until the wiper starts operation again.
Wiper
Fast
Middle
Slow
MDC1-01-513
MBFM-01-005