SAFETY
S-8
Move and Operate Machine Safely
Bystanders can be run over.
Take extra care not to run over bystanders. Confirm the
location of bystanders before moving, swinging, or
operating the machine.
Always keep the travel alarm and horn in working
condition (if equipped). It warns people when the
machine starts to move.
Use a signal person when moving, swinging, or operating
the machine in congested areas. Coordinate hand signals
before starting the machine.
Use appropriate illumination. Check that all lights are
operable before operating the machine. If any faulty
illumination is present, immediately repair it.
Ensure the cab door, windows, doors and covers are
securely locked.
Check the mirrors and the monitor in the cab for
problems.
If there is, replace the problem part (s) or clean the mirror,
camera lens and the monitor display.
Refer to Mirror section and Rear View Monitor section
for information on cleaning the mirrors, camera lens and
monitor display.
Operate Only from Operator's Seat
Inappropriate engine starting procedures may cause the
machine to runaway, possibly resulting in serious injury or
death.
Start the engine only when seated in the operator's seat.
Never start the engine while standing on the track or
ground.
Do not start engine by shorting across starter terminals.
Before starting the engine, confirm that all control levers
are in neutral.
Before starting the engine, confirm the safety around the
machine and sound the horn to alert bystanders.
SA-444
SA-426
To Next Page
Loading...
Need help?
General
