Huawei Quidway S3100 Series User Manual

Operation Manual – GVRP
Quidway S3100 Series Ethernet Switches Chapter 1
GVRP Configuration
Huawei Technologies Proprietary
1-6
Timer Lower threshold Upper threshold
LeaveAll
This lower threshold is
greater than the timeout time
of the Leave timer. You can
change threshold by
changing the timeout time of
the Leave timer.
32,765 centiseconds
1.3 Displaying GVRP
After the above configuration, you can use the display commands in any view to
display the configuration information and working condition of GVRP, and thus verify
your configuration. You can use the reset garp statistics command in user view to
clear the GARP statistics.
Table 1-4 Display GVRP
Operation Command
Display the GARP statistics display garp statistics [ interface interface-list ]
Display the timeouts of the
GARP timers
display garp timer [ interface interface-list ]
Display the GVRP statistics display gvrp statistics [ interface interface-list ]
Display the global GVRP
status
display gvrp status
Clear the GARP statistics (in
user view)
reset garp statistics [ interface interface-list ]
1.4 Configuration Example
I. Network requirements
You should enable GVRP on the switches to implement the dynamic registration and
update of VLAN information between the switches.
II. Network diagram
Switch A Switch B
E1/0/1 E1/
Switch A Switch BSwitch A Switch B
0/2
Switch A Switch B
Figure 1-2 Network diagram for GVRP configuration

Huawei Quidway S3100 Series Specifications

General

Brand	Huawei
Model	Quidway S3100 Series
Category	Switch
Language	English