Operation Manual – Login
Quidway S3100 Series Ethernet Switches Chapter 4 Logging in Using Modem
Huawei Technologies Proprietary
4-1
Chapter 4 Logging in Using Modem
4.1 Introduction
The administrator can log into the Console port of a remote switch using a modem
through PSTN (public switched telephone network) if the remote switch is connected to
the PSTN through a modem to configure and maintain the switch remotely. When a
network operates improperly or is inaccessible, you can log into the switches in the
network in this way to configure these switches, to query logs and warning messages,
and to locate problems.
To log into a switch in this way, you need to configure the terminal and the switch
properly, as listed in the following table.
Table 4-1 Requirements for logging into a switch using a modem
Item Requirement
The PC can communicate with the modem connected to it.
The modem is properly connected to PSTN.
Administrator side
The telephone number of the switch side is available.
The modem is connected to the Console port of the switch
properly.
The modem is properly configured.
The modem is properly connected to PSTN and a
telephone set.
Switch side
The authentication mode and other related settings are
configured on the switch. Refer to
Table 2-3.
4.2 Configuration on the Administrator Side
The PC can communicate with the modem connected to it. The modem is properly
connected to PSTN. And the telephone number of the switch side is available.
4.3 Configuration on the Switch Side
4.3.1 Modem Configuration
Perform the following configuration on the modem directly connected to the switch:
AT&F ----------------------- Restore the factory settings
To Next Page
Loading...
Need help?
General