Huawei Quidway S3100 Series User Manual

Operation Manual – Login
Quidway S3100 Series Ethernet Switches Chapter 3 Logging in through Telnet
Huawei Technologies Proprietary
3-6
<Quidway> system-view
# Enter VTY 0 user interface view.
[Quidway] user-interface vty 0
# Configure not to authenticate Telnet users logging into VTY 0.
[Quidway-ui-vty0] authentication-mode none
# Specify commands of level 2 are available to users logging into VTY 0.
[Quidway-ui-vty0] user privilege level 2
# Configure Telnet protocol is supported.
[Quidway-ui-vty0] protocol inbound telnet
# Set the maximum number of lines the screen can contain to 30.
[Quidway-ui-vty0] screen-length 30
# Set the maximum number of commands the history command buffer can store to 20.
[Quidway-ui-vty0] history-command max-size 20
# Set the timeout time to 6 minutes.
[Quidway-ui-vty0] idle-timeout 6
3.3 Telnet Configuration with Authentication Mode Being
Password
3.3.1 Configuration Procedure
Table 3-6 Telnet configuration with the authentication mode being password
Operation Command Description
Enter system view
system-view
—
Enter one or more
VTY user interface
views
user-interface vty
first-number [ last-number ]
—
Configure to
authenticate users
logging into VTY
user interfaces
using the local
password
authentication-mode
password
Required
Set the local
password
set authentication
password { cipher |
simple } password
Required

Huawei Quidway S3100 Series Specifications

General

Brand	Huawei
Model	Quidway S3100 Series
Category	Switch
Language	English