Huawei Quidway S3100 Series User Manual

Operation Manual – IGMP Snooping
Quidway S3100 Series Ethernet Switches
Chapter 3 Multicast MAC Address Entry
Configuration
Huawei Technologies Proprietary
3-2
 Note:
z If the multicast MAC address entry you are creating already exists, the system gives
you a prompt.
z The switch will not learn a manually added multicast MAC address by IGMP
Snooping. The undo mac-address multicast command can only remove manually
created multicast MAC address entries and cannot remove those learned by the
switch.
z To add a port to a manually created multicast MAC address entry, first remove the
entry, and then re-create the entry and specify the port as the forward port of the
entry.
z The system does not support the configuration of multicast MAC address on an IRF
port. If you do this, the system will give you a prompt that the multicast MAC address
configuration fails.
z You cannot enable port aggregation on a port where you have configured a
multicast MAC address; and you cannot configure a multicast MAC address on an
aggregation port.
3.3 Displaying Multicast MAC Address Configuration
You can use the following display command in any view to display the multicast MAC
address entry/entries you configured manually.
Table 3-2 Display the multicast MAC address entry/entries manually configured
Operation Command Description
Display the multicast
MAC address
entry/entries manually
configured
display mac-address
multicast static
[ mac-address ] [ vlan
vlan-id ]
You can use the display
command in any view.

Huawei Quidway S3100 Series Specifications

General

Brand	Huawei
Model	Quidway S3100 Series
Category	Switch
Language	English