Huawei Quidway S3100 Series User Manual

Operation Manual – 802.1x
Quidway S3100 Series Ethernet Switches Chapter 1
802.1x Configuration
Huawei Technologies Proprietary
1-18
1.5.3 Configuring Client Version Checking
Table 1-4 Configure client version checking
Operation Command Description
Enter system view
system-view
—
Enable 802.1x
client version
checking
dot1x version-check
[ interface interface-list ]
Required
By default, 802.1x client
version checking is disabled
on a port.
Configure the
maximum number
of retires to send
version checking
request packets
dot1x retry-version-max
max-retry-version-value
Optional
Defaults to 3.
Configure the
client-version-chec
king period timer
dot1x timer ver-period
ver-period-value
Optional
The default ver-period-value
is 30 seconds
 Note:
As for the dot1x version-user command, if you execute it in system view without
specifying the interface-list argument, the command applies to all ports. You can also
use this command in port view. In this case, this command applies to the current port
only and the interface-list argument is not needed.
1.5.4 Enabling DHCP-triggered Authentication
Table 1-5 Enable DHCP-triggered authentication
Operation Command Description
Enter system view
system-view
—
Enable
DHCP-triggered
authentication
dot1x dhcp-launch
Optional
By default, DHCP-triggered
authentication is disabled.

Huawei Quidway S3100 Series Specifications

General

Brand	Huawei
Model	Quidway S3100 Series
Category	Switch
Language	English